tooth factor

英 [tuːθ ˈfæktə(r)]

美 [tuːθ ˈfæktər]

网络  齿轮系数; 齿系数

机械

双语例句

• The Finite Element Analysis of Bending Stress and Tooth Form Factor for Spur Gear Teeth With Involute Profiles
  标准渐开线直齿圆柱齿轮轮齿弯曲应力和齿形系数的有限元分析
• Normal growth and tooth arrange influence oral cavity not neat reason has two, include congenital element and acquired factor.
  影响口腔正常发育和牙齿排列不齐的原因有两个，包括先天因素和后天因素。
• Conclusion In patients with severe tooth wear, absence of complete posterior tooth support was the main factor that influenced the functions of patients 'masticatory muscles. Those with incomplete posterior support had higher muscle tension and lower muscle functions.
  结论后牙支持是否完整是影响重度磨耗患者咀嚼肌功能的主要因素，后牙支持不全者肌紧张度增加，功能下降。
• Since the complexity of calculating dynamic factor and tooth form factor, the calculation of gear calculating stress is inconvenient.
  由于动载系数和齿形系数计算繁复，给齿轮计算应力的求解带来不便。
• We measured tooth mobility using T/ 2 as main and η as assist factor.
  以T／2为主，η为辅，度量牙齿的松动度。
• The Tooth Form Factor of Internal Spur Gears
  内齿轮的齿形系数
• The optimal amount of gear tooth tip modification is obtained when tooth dynamic load factor to minimum is as the optimization objective.
  以动载系数最小为优化目标，获得最优齿顶修形量。与未修形时相比，改善了齿轮传动的轮齿动态载荷特性。
• After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.
  在获得齿轮内啮合传动的齿侧间隙计算公式以后，结合齿对刚度的计算公式，推导出齿轮内啮合传动的加载重合度及载荷修正系数。
• Proposed considered resultants to the inappropriate tooth including the manufacture error, crudely services the error, the structure distortion and so on various single factor function and time the multi-factors union function automobile door lock system reliability analysis method.
  提出了考虑到不恰当的齿合量包括制造误差，粗暴维修误差，结构变形等各单因素作用及多因素结合作用时的汽车门锁系统可靠性分析方法。
• Respectively aiming at saw tooth roofed workshops and windowless workshops, compares calculation results by original building envelope cooling load calculation method with those by the cooling load factor method, finding greater deviation, and recommends using the latter.
  分别就锯齿形厂房和无窗厂房，对原围护结构冷负荷计算方法所得结果与冷负荷系数法计算结果进行了比较，二者偏差较大，建议采用冷负荷系数法计算围护结构冷负荷。